How to Improve Your EPC Rating: What to Fix First and Who Pays

Last updated:

  • The EPC score follows modelled running costs, not your actual bills
  • Assessor software tests insulation first, then controls, heating, glazing and solar
  • Each upgrade's points depend on what was fitted before it
  • A heat pump only reaches the list once a house is fairly insulated
  • Warm Homes: Local Grant has two £16,600 per home budgets in England
  • The Boiler Upgrade Scheme gives £7,500 towards an air source heat pump
  • Only a new certificate makes your better band official

Want to know which upgrade your home needs first?

Check If You Qualify
  • Gas Safe registered engineers
  • Company No. 16100301
Brick terraced house with an open loft hatch and pink insulation rolls laid in the roof space

£16,600

Local Grant cap, each budget

DESNZ guidance, July 2026

£7,500

Heat pump grant

GOV.UK

69

Band C starts at

SAP 10.2

D to G

Local Grant eligible homes

DESNZ guidance, July 2026

How to improve your EPC rating: start with what the score measures

Your EPC rating is a modelled running cost score, so an upgrade only counts if it lowers the cost the model expects. The SAP 10.2 specification says the rating is based on the energy costs of space heating, water heating, ventilation and lighting, less savings from energy you generate on site, adjusted for floor area.

Three things follow from that, and they shape every decision below:

  • It rates the building, not the people in it. The specification calls it a rating of the asset, independent of the household living there. Turning the thermostat down or using less hot water saves money but does not change the certificate.
  • Higher is better, on a scale of 1 to 100. A score of 92 or more is band A, the best EPC rating, and a home can go past 100 if it generates enough of its own energy.
  • Fuel prices inside the model matter. The RdSAP 10 specification notes that individual ratings are affected by relative changes in the price of particular heating fuels, which is why swapping one heating fuel for another can move a score up or down.

The bands run G (1 to 20), F (21 to 38), E (39 to 54), D (55 to 68), C (69 to 80), B (81 to 91) and A (92 or more). If you want to know what your current band says about your home, our guide to EPC rating D explains the middle bands. If you do not know your score yet, look it up with our EPC checker before you plan anything.

In what order should you upgrade your home?

Work from the outside in: insulation, then the small fixes, then the heating system, then glazing and solar panels. That is the order in Section 20 of the RdSAP 10 specification, the method used for EPCs on existing homes, which says the software tests improvement measures and applies them "in the order shown in this table".

Order matters because each step changes the next one. The specification says the effect of any one measure on the rating depends, in general, on the order in which measures are introduced. The points a heat pump adds, for example, depend on whether the insulation has already been modelled before it.

OrderUpgradeWhen the EPC method suggests itGrant that can pay (England)
1Loft insulationLoft has 150 mm or less; target is 270 mmWarm Homes: Local Grant, energy performance budget
2Cavity or solid wall insulationUnfilled cavity, or uninsulated solid wallWarm Homes: Local Grant, energy performance budget
3Floor insulationNo insulation under the floorWarm Homes: Local Grant, energy performance budget
4Cylinder jacket, draught proofing, low energy lightingNo jacket (minimum 80 mm), gaps not fully draught proofed, not every fitting low energyDraught proofing is listed under the energy performance budget
5Heating controls and cylinder thermostatControls or cylinder thermostat missingSmart controls are listed under the energy performance budget
6Heat pumpHouse or bungalow that is already fairly insulatedBoiler Upgrade Scheme, or the Local Grant's low carbon heating budget
7Condensing boilerExisting boiler is not a condensing modelNeither scheme pays for a new gas boiler
8Double glazing and insulated doorsSingle glazing, or outside doors that are not insulatedWarm Homes: Local Grant, energy performance budget
9Solar panelsHouse or bungalow without a thatched roofWarm Homes: Local Grant, energy performance budget

The row numbers group the specification's longer list; it also includes measures such as flat roof and room in roof insulation, biomass heating, solar water heating and wind turbines.

What the list on your own certificate is telling you

A step only appears on an EPC if it lifts the score by a set minimum: one SAP point for most measures, or half a point for a cylinder jacket, draught proofing and low energy lighting. The RdSAP 10 specification sets both thresholds.

So the list printed on your own certificate is already filtered, and nothing on it is cosmetic. If your EPC does not list loft insulation, that usually means the software found too little left to gain in the loft. Where loft or cavity wall insulation does appear, our loft insulation grant and cavity wall insulation pages show how each one can be funded.

Why does a heat pump come after the insulation?

Because the EPC method will not recommend one until the house is fairly well insulated. The specification's rule for heat pumps applies to a house or bungalow where the earlier insulation measures are no longer triggered.

The method also runs a second test. It only lists a heat pump if the rating with it is equal to or better than the rating with the alternative heating upgrade for that home. So whether an air source heat pump improves your EPC rating depends on what it is compared with: the method tests it against a more conventional heating upgrade, such as a condensing boiler or high heat retention storage heaters, and the rating follows modelled cost rather than carbon.

Two grants can pay for the heat pump itself:

  • Boiler Upgrade Scheme: GOV.UK lists £7,500 towards an air source or ground source heat pump and £2,500 towards an air-to-air heat pump, plus an extra £1,500 until March 2027 for air source or ground source heat pumps in homes heated by oil or LPG with no mains gas connection. The scheme is open in England and Wales.
  • Warm Homes: Local Grant: a separate low carbon heating budget, covered in the grants section below.

Since 28 April 2026, SI 2026/390 has removed the need for a valid EPC to qualify for the Boiler Upgrade Scheme, so the heat pump grant no longer waits for a fresh certificate. Our air source heat pump grant page covers the application, and are heat pumps worth it helps you judge whether your home is ready.

From E to C: how big is the jump?

A home at the middle of band E has to cut its modelled energy cost per square metre by about 38% to reach band C. That figure comes from the rating equation in the SAP 10.2 specification, not from any single product claim.

Example, using the SAP 10.2 equation and one illustrative starting score:

  • Below a score of about 43, the equation is logarithmic; above it, every point is a fixed slice of modelled cost. A score of 50 corresponds to an energy cost factor of about 3.08.
  • Band C starts at 69, which corresponds to an energy cost factor of about 1.91.
  • Going from 3.08 to 1.91 is a cut of about 38% in modelled energy cost per square metre of floor area.
  • A home at 60 (band D) needs a cut of about 22% to reach 69. A home already at 68 needs only about 3%.

Treat these as a guide, not a forecast. Existing homes are assessed with RdSAP 10, which uses its own fuel price table, and your certificate's starting score, floor area and heating fuel all change the result.

A cut of more than a third rarely comes from one cheap item, which is why the highest-value route from E to C usually starts with the biggest heat loss (walls or loft), adds controls, and then looks at the heating system. The same arithmetic shows why going from D to B is a much bigger project: band B starts at 81, so a home at 60 would need to cut its modelled cost by about half.

Which upgrades can a grant pay for?

In England, the Warm Homes: Local Grant pays for most fabric and low carbon upgrades for lower income households in homes rated D to G; the Boiler Upgrade Scheme helps any eligible owner with a heat pump; a new gas boiler is outside both.

The Warm Homes: Local Grant policy guidance (July 2026) sets these rules:

  • Which homes: England only, rated D to G, which the guidance defines as an Energy Efficiency Rating SAP score of 68 or below. All heating fuels are eligible, gas included.
  • Which households: a postcode in Income Deciles 1 to 2 of the Indices of Multiple Deprivation, a listed means-tested benefit, or a gross household income below £36,000 or under the guidance's "after housing costs" threshold.
  • How much: two caps of £16,600 per home, one for energy performance work and one for low carbon heating, each averaged across a council's whole project.
  • What it covers: any measure compatible with RdSAP except fossil fuel heating. The energy performance budget names insulation, draughtproofing, double glazing, energy efficient doors, solar PV, smart controls and home batteries.
  • What owners pay: owner occupiers are not required or expected to contribute. A private landlord gets one home fully funded, then pays 50% for each further home.
  • Band C is an aim, not a test. The guidance calls band C a non-binding aspiration and says fuel poor households should not be excluded because their home cannot reach C within the cost caps.

Homes across Greater Manchester follow a different route. The Combined Authority there was handed its Local Grant money directly as part of a wider funding deal, and the guidance bars it and its member councils from the national scheme. For how we help with the form and documents, see the Warm Homes: Local Grant page.

Neither grant applies in Scotland: the Local Grant is for England only, and the Boiler Upgrade Scheme covers England and Wales. Scottish homes have separate support, and our team covers Scotland as well as England.

What won't move your EPC rating?

Anything that changes how you use energy rather than how the building performs. Because the rating is an asset rating, the following make little or no difference to the certificate, even when they cut your bills:

  • A smart meter. It is not one of the improvement measures in the RdSAP 10 table, so it does not appear as a recommendation and does not change the modelled cost.
  • Your habits. Lower thermostat settings, shorter showers and switching off lights save money but sit outside an asset rating.
  • Listed status alone. The specification says a listed building or a conservation area is not, in its own right, a reason for the assessor to suppress a recommendation; documentary evidence is needed. Planning consent for the work is a separate question.

What if you live in a flat?

A flat's route is shorter: insulation, then controls, lighting, hot water and glazing. The EPC method does not recommend a heat pump for flats or maisonettes, and solar panels are a house or bungalow measure in the table.

When should you book a new EPC?

After the whole package is finished, not after each step, because the old rating stands until a new certificate replaces it. GOV.UK says an EPC is valid for 10 years and that you pay an accredited assessor for a new one, so an early reassessment costs money and records a half-finished job.

Two situations change the timing:

  • Funded work comes with one. The Local Grant guidance says upgrades need a separate post-install EPC, so a grant-funded project produces the new certificate as part of the job.
  • Landlords are on a clock. The Warm Homes Plan sets new minimum standards for private renters in England and Wales: landlords will need EPC band C across two metrics by October 2030, with a spending cap of £10,000, and that improvements made from October 2025 count towards that cap. Our boiler grants for landlords guide covers the rental rules in full.

The method itself is also changing. The GOV.UK guidance on the Standard Assessment Procedure says the Home Energy Model will replace SAP for rating homes, though its launch was delayed in June 2026, and the Warm Homes Plan says the government is consulting on new EPC metrics.

Where our team fits into your EPC plan

For homeowners and private tenants, our work lines up with the first rows of the table: insulation and smart heating controls. Further down the list, we fit air source heat pumps and help homes in England with the Boiler Upgrade Scheme, and we help with the form and documents for the Warm Homes: Local Grant.

Where the heating upgrade is a new boiler rather than a heat pump, our guide to new boiler cost explains what drives the price, and homes with no central heating at all can read about first time central heating.

FAQs

Can EPC rating be improved?

Yes, and the certificate you already have is the starting list. GOV.UK says an EPC includes steps to improve a property's energy efficiency and save money. If it still lists work you know has been done, such as filled cavity walls, the assessment may have relied on assumptions, since GOV.UK notes that the method for existing homes uses a set of assumptions about the dwelling.

Why is my EPC rating so low?

A low score usually means the model expects high running costs for the floor area. The usual causes are missing loft or wall insulation, an old non-condensing boiler, poor controls or an expensive heating fuel, and the steps listed on your certificate show which of these the software picked up.

How much does it cost to improve EPC rating?

There is no official price per band, because the cost depends on how far your score is from the next band and which steps your certificate lists. If you pay for the work yourself, VAT can lower the bill: HMRC VAT Notice 708/6 sets a zero rate on installing listed energy-saving materials from 1 May 2023 to 31 March 2027. The list includes insulation, draught stripping, heating and hot water controls, solar panels, air source and ground source heat pumps and batteries, but not gas boilers or replacement windows.

How to get EPC rating from D to C?

Find out exactly where in band D you sit, because a home at 68 is one point from band C while a home at 55 has fourteen to find. Near the top of D, a single listed step such as cavity wall insulation or better heating controls can be enough; near the bottom, expect to need several steps.

How to get a property to EPC C?

Do the work your certificate lists, then have a new EPC lodged. For a rented home in England or Wales, the date of that certificate matters, because the Warm Homes Plan says properties which will meet EPC C before October 2029 will be considered compliant with the regulations until that EPC expires, even after new EPCs are introduced.

Tap, tap, done

Check If You Qualify

Four quick steps. Tap your answers and we'll do the rest.

Sources

About This Page

FreeBoilerUpgrade.uk is an installer run by Reliant Energy Solutions Ltd (No. 16100301), incorporated on 25 November 2024. Every boiler is fitted by a Gas Safe registered engineer. We are not part of the government or Ofgem.

  • Company: Reliant Energy Solutions Ltd, company number 16100301, address 16 Suite, Turner Business Centre, Middleton, Manchester M24 1RU
  • Phone: 07599 995537
  • Email: info@freeboilerupgrade.uk

Want a second opinion on your EPC recommendations?

Ready to Start Saving?

See if your household qualifies for funded ECO4 heating upgrades through the ECO4 scheme.

100%
Free Service
60s
Application
ECO4
Eligibility check